| To: | AMPS <amps@contesting.com> |
|---|---|
| Subject: | Re: [Amps] Coil Tapping |
| From: | "Bill, W6WRT" <dezrat1242@yahoo.com> |
| Date: | Wed, 18 Jul 2012 08:36:35 -0700 |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
ORIGINAL MESSAGE: On Mon, 16 Jul 2012 22:22:46 -0500, K9WXR wrote: > >Leave the tubes in the sockets, remove the plate caps, REPLY: For the initial rough tuning you can leave the plate caps disconnected, but for the final settings, connect them. The tube's plate-to-ground capacitance is an important part of the total plate tuning capacitance. 73, Bill W6WRT _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] Neon xfmr for HiPot, Randall, Randy |
|---|---|
| Next by Date: | Re: [Amps] Neon xfmr for HiPot, Colin Lamb |
| Previous by Thread: | Re: [Amps] Coil Tapping, bill wylde |
| Next by Thread: | Re: [Amps] Coil Tapping, Steve Flood |
| Indexes: | [Date] [Thread] [Top] [All Lists] |