Are we looking at the same amp? It looks like my output loading cap in my
legal-limit amp, and it's never arced even into a high SWR.
The output loading capacitor only has to handle about 300 volts.
As long as the plates are aligned end-to-end, it should work OK. Just look
through the plates at a light, and rotate it throughout its entire range.
Check for the plates not centered or almost touching.
73, Mike
www.w0btu.com
On Fri, Jan 17, 2014 at 11:00 AM, <amps-request@contesting.com> wrote:
> From: Bill <dezrat1242@wildblue.net>
> To: amps@contesting.com
> Date: Fri, 17 Jan 2014 08:58:08 -0800
> Subject: Re: [Amps] Building an Amp 101
>
> On 01/17/2014 08:23 AM, Vic Rosenthal wrote:
>
>> You don't need to be an expert or have a lot of special tools. Look at my
>> amp,
>>
>> <http://www.qsl.net/k2vco/4CX1000A/K2VCO%204CX1000A%20Amplifier.html>
>>
>> The only power tools I used were a drill press and a hand-held jigsaw (a
>> reciprocating sander can be used to make scratched up panels look nice).
>>
>
> REPLY:
>
> You've done a beautiful job Vic, but I have two concerns: I think both
> your bandswitch and the output loading capacitor are seriously under-rated
> for a legal limit amp. You didn't ask for advice, but I do want to help.
>
> 73, Bill W6WRT
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|