I've always included a wire grill under those screws. I don't recall what
voltage the fan required. It may have been 115 VAC.
73,
Ed W0YK
On Oct 20, 2017 11:48 PM, gudguyham--- via Amps <amps@contesting.com> wrote:
>
>
>
>
>
> -----Original Message-----
> From: gudguyham <gudguyham@aol.com>
> To: jim <jim@audiosystemsgroup.com>
> Sent: Sat, Oct 21, 2017 2:47 am
> Subject: Re: [Amps] Extra Fan Mod for 87A
>
>
> I installed one for a customer. The back of the amp has threaded inserts to
> accept the normal bolt pattern of the typical muffin fan. I simply used a
> long enough screw to reach to the amp rear panel.
>
>
>
> -----Original Message-----
> From: Jim Brown <jim@audiosystemsgroup.com>
> To: Amps Amps <amps@contesting.com>
> Sent: Sat, Oct 21, 2017 1:10 am
> Subject: [Amps] Extra Fan Mod for 87A
>
> What does it take to add this to an 87A? Are there mounting holes and a
> cutout where I can simply add a generic fan and run it from 12V?
>
> Thanks and 73, Jim K9YC
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|