Amps
[Top] [All Lists]

Re: [Amps] LDMOS amp off battery?

To: Manfred Mornhinweg <manfred@ludens.cl>
Subject: Re: [Amps] LDMOS amp off battery?
From: Roger <ai7rogerroger@gmail.com>
Date: Mon, 23 Oct 2017 13:29:14 -0700
List-post: <mailto:amps@contesting.com>
6v batteries would be a better option.


73, Roger
W7TZ
CN83ia
Grid Busters
w7tz.webs.com

On Mon, Oct 23, 2017 at 10:49 AM, Manfred Mornhinweg <manfred@ludens.cl>
wrote:

> Steve,
>
> Is anyone running a 50V LDMOS amp off a 48V battery system?
>>
>
> I have considered it, but not done yet. I generate my own power, with a
> turbine in a creek, and in summer I can generate only about 400 to 700W, so
> I absolutely need batteries to run a legal limit amp.
>
> But there are two choices: A local battery bank just for an amp, or using
> the main battery bank I have in place for the whole house - in that case
> the amp needs just its normal AC supply, and my DC-AC inverter takes care
> of the rest. That solution is cheaper to implement in my situation, but
> incurs in higher losses.
>
> I've been rolling this idea around for a while for portable use, but the
>> problem is a "48V" battery system on equalise is more than a little bit
>> more than 50V - more like 58V !
>>
>> Any ideas?
>>
>
> First idea: Don't equalize the batteries while you are operating! During
> operation keep the charger regulated to 50V. The system voltage will then
> vary between about 48 and 50V as you operate, which should be OK. The
> batteries will lose charge, but will not go into deep discharge. After the
> operating session, raise the charge voltage to whatever is necessary for a
> complete charge, including equalization once every several months. Even if
> the voltage remains applied to the LDMOSFET, it's no problem while it's not
> being driven, since its maximum drain voltage rating is well over 100V.
>
> And another idea: Use a battery bank of whatever voltage you like, either
> lower or higher but not 48V, run the batteries at their proper voltage, and
> use a switching regulator to produce a stable, clean 50V. Depending on the
> battery voltage that can be a buck or a boost circuit. It gives you the
> advantage of a stable, constant supply voltage, and if the battery voltage
> is reasonably close to 50V, then the size and weight and cost of the
> regulator is small.
>
> Manfred
>
> ========================
> Visit my hobby homepage!
> http://ludens.cl
> ========================
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>