It is indeed a spline.
Henry used spline.
73
Jim W7RY
On Fri, Oct 19, 2018 at 9:31 AM Mike & Becca Krzystyniak <k9mk@flash.net>
wrote:
> Greetings,
>
>
>
> I am repairing a Henry 1KD5 for a friend. It was a 80-15m model that
> was upgraded to 80-10m and no longer worked on 40-20m. I found that the
> cam
> shaft switches used for fixed tank C were not band aligned with the
> bandswitch leaving padder caps in place on 40/20m.
>
>
>
> Simple to fix right? My problem is I went to loosen the shaft coupler
> and looked for the allen screws. Difficult for me to see but with some
> visual aids I see that this amp has what looks like a phillips spline type
> screw. Approximately 2mm or 0.079" inside the shaft fit, but it appears to
> be a X shaft spline. What is the proper name for this screw and tool that
> would be used to remove it?
>
>
>
> Also there are 4 screws, 2 each on 90 degree offsets. Two I can get
> to,
> and the other 2 are accessible maybe with right angle tool, like an allen
> wrench was made to do. Any hints on access or maybe swap the couple out
> completely for one that uses standard hardware.
>
>
>
> Many thanks in advance from the not mechanically inclined.
>
>
>
> 73's Mike K9MK/5
>
>
>
> Off reflector email: k9mk at flash dot net
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|