Hi All,
I am looking either for plans for an 80 meter mono-band amplifier optimized for
the RTTY portion of the band or an actual amplifier itself. I want an all tube
amplifier, including the power supply. I want no solid state components at all
in this amp. I would like it to be very "overbuilt" so that when I run it at
500 watts RF power, it is just idling. Of course, this is for RTTY, so it would
be continuous duty at 500 Watts. I do not want to operate any higher than about
5oo watts.
I would like full metering. It does not need to be rack mounted, but I do want
a rugged chassis, and excessive ventilation to keep the tubes safe and so that
those tubes last a long time. I do want it to be fully enclosed to keep four
and two legged children safe from the lethal voltages.
Any ideas or locations for plans would be greatly appreciated.
Thank you so much!
73,
Joe Herdler KB0TXC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|