Amps
[Top] [All Lists]

Re: [Amps] Econco Tube rebuilding

To: Larry <pacer99@aol.com>, Amps@contesting.com
Subject: Re: [Amps] Econco Tube rebuilding
From: Steve Bookout <steve@nr4m.com>
Date: Wed, 29 Jan 2020 08:22:31 -0500
List-post: <mailto:amps@contesting.com>
Larry,

Unfortunate.

Some have mentioned they may not be rebuilding tubes below a certain plate dissipation.   Maybe so, but they should at least tell me to 'go away'.

Someone is rebuilding these tubes as RF Parts is selling rebuilt 3cx1200a7's.

I bought an amp that has a real dud of a 3cx1200a7 in it and thought I would look at getting it rebuilt.  As some have mentioned, if you use your amp correctly, and it's tuned properly, the tubes will last a very long time.  I have a Henry 3K Classic MKII with this tube in it from mid eighties and it still easily puts out full power.

It may be a better choice for me to use Ameritron parts and turn it into a AL-1500.  It's an Al-1200 now, and I have 8877's

If anyone knows the parts needed to do this, as I'm sure others have done it, I would appreciate any info. I can think of parts specific to the 8877, such as fil xfmr, tube socket, fil choke, grid trip stuff, grid meter shunt, etc.

It would probably be cheaper in the long run anyway.

73 de Steve, NR4M

On 1/28/2020 10:03 PM, Larry wrote:
steve,

my experience with Econco was less than satisfying. they rebuilt two different tubes for me and each turned out to have intermittent grid shorts.

the positive is that they refunded my money both times.

good luck.

larry    n7dd


-----Original Message-----
From: Steve Bookout <steve@nr4m.com>
To: Amps <Amps@contesting.com>
Sent: Wed, 29 Jan 2020 1:57
Subject: [Amps] Econco Tube rebuilding

Hello all,

Has anyone on this group had a tube(s) rebuilt by Econco?

Will they work with the 'average guy'?  After all, money is money.

I've sent emails to them about rebuilding a 3cx1200A7 and all I've
gotten in response is 'crickets'.

If they only work with commercial accounts, or some such thing, I would
appreciate at least an email stating that.

Maybe someone has direct contact info they would be willing to share
with me.

73 de Steve, NR4M

_______________________________________________
Amps mailing list
Amps@contesting.com <mailto:Amps@contesting.com>
http://lists.contesting.com/mailman/listinfo/amps <http://lists.contesting.com/mailman/listinfo/amps>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>