Just a reminder that the TS-930 (and probably the 940) utilizes an isolated
ground for the mic connection. I think that it is isolated inside the radio
with an inductor to ground. What I had to do when switching mic's for SO2R
was to isolate and switch the grounds and not let them come in any contact
with any other ground. As a side note, I'm now using Icom radios and just
this last week I thought I would install a simple PB switch to switch the
hot from my mic between 2 radios, bad hum! So I went back to the relay
method of switching hot and ground that I had incorporated for my 930's.
73-Mike W9RE
--
CQ-Contest on WWW: http://www.contesting.com/_cq-contest/
Administrative requests: cq-contest-REQUEST@contesting.com
|