Either would work just fine electrically,,
BUT.........
There always is a but isn't there.......
Check your soil,,,, how do pop cans survive in your location.
I use that ALUM wire for all my in the air antennas. But I can not
Bury it.
The soil here eats it up alive. A pop can even with it's paint on the
outside and coating on the inside if buried here in like 6 months it's
almost gone.
So that might be a problem.
I had some of that super heavy ALUM ground wire stuff. I mean like
1/4" thick stuff? In less than two or three years it was gone. I had
it buried from an old TV antenna install.
Joe WB9SBD
Sig
The Original Rolling Ball Clock
Idle Tyme
Idle-Tyme.com
http://www.idle-tyme.com
On 6/16/2013 10:59 AM, Robert Shohet wrote:
Hi,
I noticed an ad in this weeks Tractor Supply co. flyer of 14 ga and
17 ga electric fence wire
1/2 mile 17 ga for $24.99
1/2 mile 14 ga for $49.99
1) Is there any advantage in the efficiency of radiation for a
vertical between using
Copper vs. Aluminum wire?
2) Are there any mechanical or other advantages of using Copper vs.
Aluminum?
3) Is 17 ga wire thick enough or should the 14 ga be used?
I am interested in the radials lasting – the difference in cost is
immaterial to me.
Please advise. Tnx & 73
Happy father’s Day!
Bob KQ2M
kq2m@kq2m.com
www.rlsfinancialgroup.com
www.kq2m.com
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest