Thanks Jim!
So finally I will use LMR-240-UF
Will order round cable snap-its
Seems that part number 0431164281 will be loose on the coaxial and will not
be held near the connector
Anyone tried part number 0431173951 with LMR-240-UF? Will close on this
cable? Will be very bad if I buy a lot of them and then I see that don´t
close.
Thanks,
Jorge
CX6VM/CW5W
-----Mensaje original-----
De: Jim Brown [mailto:jim@audiosystemsgroup.com]
Enviado el: martes, 17 de junio de 2014 01:22 p.m.
Para: Jorge Diez - CX6VM; Rfi List
Asunto: Re: [RFI] clamp on ferrites at Mouser
On 6/17/2014 5:44 AM, Jorge Diez - CX6VM wrote:
> What I understand is that the # 31 is good for frequencies below 5
> MHz, but my question is what to put in internet modem cables,
> transformer notebook, cable RS232 as don´t know where frequencies they
are.
We put chokes on these cables so that they will not radiate trash on our ham
bands, so it is OUR frequencies that determine the chokes. For example, if
we want to kill RF noise on 40 and 20M, we wind the chokes for those
frequencies.
73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|