John,
Go to the Logic homepage http://hosenose.com
and click on the SARtek link, near the bottom of the page. Then download the
software. This is free. It was written to be used with a rotor control
card, but can be used stand-along to do what you want. I use it.
Jim W4LC
----- Original Message -----
From: "John - vk4cej" <vk4cej@hamsnet.net>
To: <rtty@contesting.com>
Sent: Sunday, December 23, 2001 00:14
Subject: [RTTY] slightly off topic
> I know that this posting is not precisly to do with rtty, but an answer
may
> certainly help me work more of that mode.
>
> I have been looking for a small stand alone program that does beam heading
> calculations... I know that there are some available but the ones I have
> seen do not do what I want...... I want one that, when I enter my
latitude
> and londitude will then allow me to type in a call prefix and will show me
> the short and long path bearings from my qth. I know that there are
> logging programs that do this, but I want something that is small and
> standalone. Does anyone know of such a program and can point me to it,
or
> alternatively, tell me where I can get hold of the formulae for doing this
> and I will have a go at making something myself.
>
> John - vk4cej
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
|