RTTY
[Top] [All Lists]

Re: [RTTY] AFC and NET: No, thanks

To: <dezrat1242@ispwest.com>, <rtty@contesting.com>
Subject: Re: [RTTY] AFC and NET: No, thanks
From: dj3iw@t-online.de (DJ3IW Goetz)
Date: Wed, 20 Oct 2004 22:07:56 -0000
List-post: <mailto:rtty@contesting.com>
AMEN to that!
73 de Goetz
dj3iw@t-online.de
----- Original Message -----
From: "Bill Turner" <dezrat1242@ispwest.com>
To: <rtty@contesting.com>
Sent: Wednesday, October 20, 2004 6:19 PM
Subject: [RTTY] AFC and NET: No, thanks


> On Wed, 20 Oct 2004 13:58:59 +0200, f6irf@free.fr wrote:
>
> >FSK users: You will never forget to remove the AFC and reset to 2125 when
> >going to S&P:  N1MM automatically resets MMTTY to your FSK freq pair (and
> >toggles the AFC according to the context - IE AFC on when CQ'ing / AFC off
> >when a station has been decoded  -  AFC-off+ reset to default mark when
going
> >S&P )
>
> _________________________________________________________
>
> For what it's worth:  IMO, AFC should NEVER be used during a contest
> and here's why.
>
> When you're doing S&P and tuning across the band, AFC will reach out
> and "grab" the other station before you have it correctly tuned in.
> As a result, your TX frequency will be off from your RX frequency by a
> certain amount.  The only way to compensate for this is if you're
> using AFSK, you can turn on both AFC and NET, but why bother since you
> need to turn them both off when CQing.  Just use RIT for what it was
> intended.  Actually, I don't even use RIT.  When CQing I use split A
> and B VFO's, thereby allowing me to tune with the big knob instead of
> the little one.  Either way is better than AFC/NET.
>
> AFC and NET:  Spawn of the devil.  :-)
>
> --
> Bill W6WRT
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>