You may be able for find some suggestions in AA5AU's RTTY Contesting
web site - www.rttycontesting.com. Otherwise, I suggest asking on
the N1MM Logger e-mail list on Yahoo and contacting West Mountain
Radio's support desk.
It would appear that your issue is in configuring the N1MM Digital
Interface for your Rigblaster Advantage - that falls directly in the
portfolio of West Mountain Radio support.
73,
... Joe, W4TV
On 3/2/2014 3:12 PM, David Tanks wrote:
Hello gang. I have not been able to get the above combination to work on my
Windows 7 desktop, no matter what I do. The only way it works is if I use an
old XP machine and the W3YY interface.
MMTTY works fine standalone( works in either FSK or LSB; should it?, if MMTTY
is set up for FSK? ). When I start N1MM and transmit, I only get a single
constant tone.
The radio's serial port is connected to the computer via a Belkin USB to serial
adapter( Com 6 ). That apparently is working fine, as I can change frequency on
the radio, and in N1MM the frequency follows it.
The Advantage is on Com 5( a USB cable from the Advantage USB port to a USB
jack on the computer ).
I have the cable for the Advantage for CW/FSK to the ACC2 jack on the radio
hooked up.
Visits to the West Mountain Radio website and N1MM's website have not been
productive in solving the problem.
What am I missing? I would like to have this running all on the same computer
and not have the Advantage doing only digital operations.
There are so many variables in these programs that it only takes 1 to screw it
all up; it can be very aggravating!
Thanks in advance.
73, David AD4TJ
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|