For information on setting up to run 75 baud RTTY with WriteLog using either
MMTTY, 2Tone or WinRTTY, go here:
http://www.rttycontesting.com/tutorials/writelog2/75-baud-rtty-setup/
73, Don AA5AU
From: Bill Turner <dezrat@outlook.com>
To: RTTY Reflector <rtty@contesting.com>
Sent: Friday, September 18, 2015 9:52 AM
Subject: [RTTY] Upcoming 75 baud contest
The BARTG 75 baud Sprint contest is this coming Sunday.
Date, time and rules at: http://bartg.rsgbcc.org/cgi-bin/hfreadcal.pl
Remember, this is the SEPTEMBER contest, not April.
There are the four steps to change MMTTY to 75 baud:
I use FSK only, but I assume this applies to AFSK as well. If not,
please let me know.
1. Start MMTTY and go to Options>Setup MMTTY and select the
Demodulator tab.
2. At the bottom, UN-check the box that says "Fixes 45.45 baud".
3 Go to the Decode tab and change the baud rate to 75.
4. Click OK. Do not skip this step or changes will not be saved.
This is a short contest - just four hours but lots of fun. 75 baud
RTTY plays differently from 45 baud. Please post your observations on
the Reflector after the contest.
See you there!
73, Bill W6WRT
RTTY List Administrator at contesting.com
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|