I experienced this a couple times during the contest. I don't use the
keyboard much and do it all with the mouse, but the "Right click=Enter"
option should duplicate the experience.
I know why it occurs but not what I did to put the cursor into that
position. It happens when the cursor is in the call sign field when
Enter/Right Click is sent. I'm not sure what I did when clicking through
the other operators name/state. I only handled a hair over 300 calls in the
NAQP and it might have happened 5-8 times. Unfortunately, I'm not watching
the Entry window but watching the digital window so I'm not sure what I
did, assuming it's not an application issue, to cause it.
But you aren't alone if that makes you feel better.
David - K2DSL
On Mon, Jul 18, 2016 at 12:11 AM, RLVZ--- via RTTY <rtty@contesting.com>
wrote:
> Hi Guys,
>
> I was going to post my question on the N1MM logger+ Digital reflector, but
> since Don brought up a related subject, and since rtty@contesting .com is
> easier for me to post messages on, I'd like to ask the following question
> about N1MM Logger+:
>
> For this weekends NAQP-RTTY Test, I was using N1MM Logger+ V.1.0.5785.0
> (which I believe is the latest version) and using ESM. ESM worked
> flawlessly
> when running stations. But while hunting MULTS in S&P mode I frequently
> had problems. After entering the other stations Callsign in the Callsign
> field and pressing "Enter" the first time, ESM would always send my
> Callsign
> just as it should. But after filling the logging fields with the proper
> received message and then pressing "Enter" the second time in order to
> send
> my exchange and automatically log the Qso, about 30% of the time Logger+
> sent my Callsign again rather than sending my report and logging the Q.
> That
> really messed me up and may have cost me logging some Q's because of it.
> So I'm wondering if anyone else experienced a similar problem?
>
> Thanks & 73,
> Dick- K9OM
>
>
>
> In a message dated 7/17/2016 11:16:18 A.M. Central Daylight Time,
> rtty-request@contesting.com writes:
>
> Message: 1
> Date: Sat, 16 Jul 2016 17:58:33 -0500
> From: "Don Hill AA5AU" <aa5au@bellsouth.net>
> To: "'RTTY Reflector'" <rtty@contesting.com>
> Subject: [RTTY] N1MM Exch Message when using ESM?
> Message-ID: <000d01d1dfb5$950bfb00$bf23f100$@net>
> Content-Type: text/plain; charset="us-ascii"
>
> OK, I give up. How do your properly set up your F2 (EXCH) RUN message when
> using ESM?
>
> I want to send the other station's callsign ONCE with my report starting
> on
> a new line.
>
> Thanks,
> Don AA5AU
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|