Enjoying this thread ;-)
So many choices, lots of great filters, so much fun!
Okay, back down to earth.
Wanted to reply to Jim's comment below:
Why can't the INRAD 2.4 filter fit into the N-1 or N-2
filter socket and be cascaded with the INRAD 2.8? I
was hoping to do this myself. Are the pin
configurations different for the "permanent" socket
and the "N" sockets? I didn't think there was any
difference.
73 all,
Barry N1EU
--- Jim Reid <jreid@aloha.net> wrote:
>
> Of course, you cannot add the 2.8Khz filter for
> improved CW note, and the new 10 pole 2.4kHz
> filter in the same rig: they both go into the same
> socket in the Omni VI. That is the permanent first
> socket that is "in" the firtst IF path all the time,
> and
> not switched in/out via a button push. You must
> decide if you want to improve your SSB selectivity
> capabiltiy, or how you sound on CW!
>
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|