Hello gang:
I need some advice from those who have used successful remote setups with
the Peg.
The scenario is this: Wish to install the Peg (that I do not have
yet) at a remote tower site, and keep the computer at the shack.
Since the serial connection is at 56k, I would need to use a wideband
duplex connection, I assume.....
In other words, I would have to split the TX/RX data into a "4-wire"
arrangement for use on a simultaneous xmit/receive UHF or Microwave link
at wideband deviation.
Has anyone done this? Is there a simpler way? What about phase delays on
the 4-wire duplex link?
Since the link would be wideband, could a modem simpler than the
quadrature-phase-amplitude modulation types be used?
Appreciate any and all suggestions...
Tnx & 73,
Perry w8au
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|