[TenTec] Re: Ten-Tec Orion - Initial Impressions

[k6se@juno.com (k6se@juno.com)]

In my post about the Orion, there were a couple of errors (senior
moments):

When I mentioned that the Orion at 50 watts output didn't appear to drive
my amp enough on SSB, I said that increasing the mike gain "cured" this. 
I meant to say, "Increasing the power output of the Orion cured this".

Regarding split operation, I said:

   "a) Press the A/B button to put both VFOs on the same freq."

The correct button is the A>B button.

73, de Earl, K6SE