On back panel is antenna switch. Go to and fro with that switch to clean
contacts. Good Luck!
73, Mike N4NT
----- Original Message -----
From: "charles timothy" <two2first@yahoo.com>
To: <tentec@contesting.com>
Sent: Sunday, June 27, 2004 4:27 PM
Subject: [TenTec] ten tec omni 546 c
> Hello I am have trouble with my ten tec omni 546 C.I am rx more noise than
signal on all bands ;I presently work 10-20 meters . (2)A very loud tone on
18.000.0 which pins the s meter full to the right;I rec no signal as if
the band is dead.(3)Sensitivity is very poor unless there is a strong
signal on the frequency.
> Tnx in advance for your reply
> Sincerely Charles (8P6ET)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|