Hello,
my Orion is in the shack for a few days and I have a question, that's
probably easy but I could not find an answer.
I have an old slow non QSK Amp, so I set the T/R Delay in the TX menu
to some convenient value. I am using Amp 1 output for keying.
That works fine for CW.
However I found that the delay that is set there applies also to SSB
mode. That means, when releasing the PTT on the mic, the Orion waits
until the T/R delay is over and after that it switches the Amp to RX.
Of course I can go to the menu and change T/R delay back to zero
when working SSB. But is there a way so that T/R delay applies ONLY
to CW mode?
Many thanks and 73 de
Chris, DL4YAO
_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|