Thanks for the suggestions about my clock problem.
I did finally call Ten Tec. It was suggested to put a 'scope across the clock
XTYL to see if it was working. Yup. Another look at the schematic showed a
variable cap. across the XTYL for fine tuning the time. After checking out the
adjusting slot orientation- one short turn to exercise it- then back to where
it had been set and it started right up.
73 de Dave in NH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|