Re: [TenTec] Frequency accuracy...

[Phil Howlett <w9xx@direcway.com>]

I leave all those foolish little screws out. The 4 cover screws on the sides 
are enough to hold things together. Without all those screws,  I can remove 
the bottom cover quickly without turning the radio off and having it cool 
down much when the referance osc is to be adjusted.

W9XX


----- Original Message ----- 
From: "Gary Tuck" <gtuck@mac.com>
To: "Ten Tec Mailing List" <tentec@contesting.com>
Sent: Thursday, December 30, 2004 3:22 PM
Subject: [TenTec] Frequency accuracy...


> Thank you all for comments.  My readout was 19999.900 when zerobeat to 20 
> mHz WWV--so 100 hz off.  My,  it doesn't take much to change the 
> frequency!  A hairs breadth got me within 6 hz so that is plenty close 
> enough. Didn't have the proper tool (my minor collection is more suited to 
> the days of tuning slugs in a HW 101 and Drake B line.) So, had to rig one 
> up.  Also glad I remembered I'd gotten a set of Torx drivers a couple of 
> years back.  A #10 does the job better than the little tool TT gives us. 
> Again, tnx.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec