| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] MODEL 219 Filter |
| From: | dnelsen@integraonline.com |
| Reply-to: | tentec@contesting.com |
| Date: | Sun, 30 Jan 2005 18:07:36 -0800 (PST) |
| List-post: | <mailto:tentec@contesting.com> |
> I've been looking at the Model 219 250Hz filter being sold by TenTec. I'm > curious if this is compatible (the same, perhaps?) as the 219 that was > available for the Argosy 525D? > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > Try checking the application table at INRAD's website. Dave AB0N _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] MODEL 219 Filter, Steve N4LQ |
|---|---|
| Next by Date: | Re: [TenTec] Omni 6 filter jumper, Tommy |
| Previous by Thread: | Re: [TenTec] MODEL 219 Filter, Steve N4LQ |
| Next by Thread: | [TenTec] WTB: Paragon RS-232 serial interface board, Jerry Volpe |
| Indexes: | [Date] [Thread] [Top] [All Lists] |