Hi All,
I have an original Titan that has not been used for about10 years. I am now
very concerned that the PSU might have problems if I was to power it up.
I do remember that my fan was rather noisy when I first purchased the amp.
The noise was from the fan unit being too tightly coupled to the chassis.
As far as I remember I just slackened the fixing bolts a little, and this
reduced the noise from the motor considerably.
If it is the air noise due to the flow rate that is bothering you I would
not recommend that you reduced the flow rate by any means as those tubes are
getting very expensive. Get noise reducing mic and headphone set instead.
73
Tim g4lmh
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|