Turn the ALC control completely clockwise and leave it there always. Does
that help?
Don, W4DON
----- Original Message -----
From: Robert & Linda McGraw K4TAX
To: tentec@contesting.com
Sent: Thursday, May 19, 2005 9:02 PM
Subject: [TenTec] Omni D Schematic/Manual
Acquired a Omni D that has a low power output (35 - 45 watts) problem on all
bands into 50 ohm load. I need a schematic or manual and suggestions. Power
supply is running 13.5 V at the radio under load. Draws about 8 amps under
tune (LOCK) condition.
Thanks in advance
73
Bob, K4TAX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|