| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Orion CW operation |
| From: | DK2GZ@aol.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 31 May 2005 01:46:20 EDT |
| List-post: | <mailto:tentec@contesting.com> |
Hello Tim I think you are using firmware 1.372. Set the qsk-delay to 5% or reinstall firmware 1.371. 73 de Harry, DK2GZ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion Noises- NOT, Phil Florine |
|---|---|
| Next by Date: | [TenTec] RX 340 vs Orion RX comparison, designer |
| Previous by Thread: | [TenTec] Orion CW operation, k3hx@juno.com |
| Next by Thread: | Re: [TenTec] Orion CW operation, k3hx@juno.com |
| Indexes: | [Date] [Thread] [Top] [All Lists] |