Great solution! Thanks.
Scott K4VWK
---------- Original Message ----------------------------------
From: yash@aol.com
Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 07 Jun 2005 15:25:16 -0400
>Hi to all.
> Let me add my 2 cents worth on this cable problem. I cut the mic cable
>about a foot back of the mic body ,spliced in a 4 foot section of radio
>shack
> mic cable and did a careful solder job of the wires ,end to end ,slid
>a tiny section of shrink tube over each connection and a larger section
>over the cable
> shrunk the tubeing and had a nice ,professional looking splice on the
>cable. It was just slightly larger than the cable itself. Did the
> same thing on the other end ... end of problem. Don't look for Heil 4
>or 5 pin XLR looking connectors ,you will not find them easily.
> Everybody have a great day.
> dale K8QI
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|