| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 8 Pins? |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 21 Jul 2005 16:08:04 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
No, Mike. No more than 8 pins would be needed. A multifunction mike stand could serially encode all the commands and use a 2 wire bus. Its done all the time, on other control circuits. Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] pks31 et al internal? was: [OT] FCC says CW dead?, Tom Azlin, N4ZPT |
|---|---|
| Next by Date: | Re: [TenTec] orion/jupiter, yash |
| Previous by Thread: | Re: [TenTec] 8 Pins?, Mike Hyder -N4NT- |
| Next by Thread: | Re: [TenTec] 8 Pins?, Richard Detweiler |
| Indexes: | [Date] [Thread] [Top] [All Lists] |