the Omni has space for 3 filters, the standard 2400 Hz SSB, a narrow 1800 Hz
SSB, and 500 Hz CW. I would like to instead use the standard SSB, a 500 Hz CW
and 250 Hz CW in these three sockets. Apparently need to equalize gain for
the two CW filters.
What are you realy trying to do?----- Original Message -----
From: "Michael Tortorella" <w2iy@verizon.net>
To: <tentec@contesting.com>
Sent: Monday, August 22, 2005 01:30
Subject: [TenTec] cw filters in omni
> Hi to the list,
> I would like to use two CW filters (217 and 219) in my Omni C. It has
> positions for the 1.8 kHz (218) and 500 Hz (217) filters. Would like to
put
> the 250 Hz (219) in place of the 1.8 kHz but the manual sayd the IF amp
does
> not have enough gain for two CW filters. This is essentially the same
reply
> I got from an inquiry to TenTec service "the IF amplifier needs to be
> modified." Has anyone done this before? Any advice and/or circuits known
> to work?
> Thanks and 73
> Mike W2IY
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|