| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] cw settings |
| From: | Barry Gross <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 18 Nov 2005 14:25:24 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
On 11/18/05, Bob Cunnings <cunnings@lectrosonics.com> wrote: > > I was interested in total rise time, so I measured from 0% to 100%, Going by the standard 10-90 measurement, a setting of 8 - like I said . . . Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] cw settings, Bob Cunnings |
|---|---|
| Next by Date: | Re: [TenTec] TenTec CW filters or Inrad?, Denton |
| Previous by Thread: | Re: [TenTec] cw settings, Bob Cunnings |
| Next by Thread: | Re: [TenTec] cw settings, Ken Brown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |