A WELL done.... thank you for your fine job... and great PDF... Jim Reed.
----- Original Message -----
From: Rick Williams
To: tentec@contesting.com
Sent: Wednesday, December 21, 2005 13:39
Subject: [TenTec] 1208 kit PCB Fault
Recently I constructed a Ten-Tec 1208 6 metre transverter kit. I ran into
problems with the tuning of the transmit stage. (Factory staff were there
to offer assistance, however, they were not able to solve my particular
problem.) After much troubleshooting I found what I believe is a PC board
fault. I have written up the problem and solution on my website.
http://www3.telus.net/ve7tk/1208%20mod.pdf
If you are building a 1208 transverter kit you may want to consult the
article to determine if you have a potential problem with your PCB. After
modifying the PCB I had a successful 6 metre QSO last evening so the
transverter is now working quite nicely.
Finally, I have informed Ten-Tec of the problem.
Season's Greetings to all!
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|