NO! User 2 is the way to get into the update mode when the rig is locked
up. I have recently had this happen to me twice and nothing worked but
reloading the firmware by using the User 2 button. Recall did not work at
all.
Toby W4CAK
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, December 22, 2005 9:30 PM
Subject: Re: [TenTec] Orion problem
> On 12/23/05, Toby Pennington <toby423@earthlink.net> wrote:
> >
> >
> > Don, Hold user 2 in while turning the power on and this will put you
into
> > the firmware update mode, and then reload the firmware that you were
> > using.
> > This may be the only way to unlock the rig.
>
>
> Don't you mean to hold "Recall" in while turning the power on?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|