Grant-
Thanks. It is enabled. I don't see anything about enabling on a port,
though. In any event with it set to enabled, punching the tune button
results in it tuning on ANT 1 but not ANT 2. Does yours tune on both ports?
Bob W2WG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Grant Youngman
Sent: Saturday, February 18, 2006 3:53 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Orion1 Tuner on TX port 2
Do you have the tuner enabled in the TX menu?
Grant/NQ5T
>
> I think for the first time (I have had the rig 1+years) I
> tried to get the internal tuner to tune with the main TX
> assigned to ANT1. Nothing happened.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|