| To: | w9kir@dpc.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni V problems |
| From: | Ralph Matheny <mathenyr@marietta.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 26 Feb 2006 20:13:12 -0500 (EST) |
| List-post: | <mailto:tentec@contesting.com> |
The whine you hear on 160M may be the "filter cap" on the display board on the front panel. Mine did that a few years back. Replaced the cap-- 100ufd if I remember--and that cured the noise which only seemed to bug the low end of 160--and all was well. No advice on the other problem. 73 Ralph Matheny K8RYU 207 Gibbons Place Marietta Ohio 45750 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Orion II Noise Blankers, Lee A Crocker |
|---|---|
| Next by Date: | Re: [TenTec] Orion II Noise Blankers, Kc9cdt |
| Previous by Thread: | [TenTec] Omni V problems, Lowell Schroeder |
| Next by Thread: | [TenTec] 2591 tone, Ariel M. Elam |
| Indexes: | [Date] [Thread] [Top] [All Lists] |