Re: [TenTec] settings for PR40, W2IHY, Orion I,and V2 firmware - FYI

["Mark DeBord" <markinkpt@hotmail.com>]

OK, I am almost using the same settings for V1 except for  the 50 and 100. 
For V1 I set them at 6 and 0. In V1 I have the mic gain set at 50 and the TX 
EQ is flat. I also run the bandwidth at 3000 and 50.
The Drake is set for 4k for initial testing but open it up to 6k as well.

With V2 I have also played with the following settings starting at 50 to 
3200

12, 4, -4, -10, -4, 4, 14, and 16

This was not as pleasing to me, but does add a few more highs. To some, it 
might sound ok.

Hope this helps.


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec