Bob
The ALC biases the RF to avoid clipping. In an amplifier, the exciter ALC
is applied as a bias to avoid the same thing. The Argo
does not provide ALC to an amp. If the amp can create an internal
ALC by biasing, that should work.
Most amps I know of use outside (EXCITER) ALC to do this.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Bob Scott
Sent: Tuesday, October 10, 2006 4:17 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Argonaut V and an amplifier
Thank you Craig and the others for responding.
So the RF sensing switch takes the place of a keying control output that
apparently does not exist in the Argo V? Is that what the AL output
is? Have never used an amp before.
Thanks and 73,
Bob - W4ZY
K4IA@aol.com wrote:
>
> In a message dated 10/10/2006 8:51:35 A.M. Eastern Standard Time,
> k3miy@csonline.net writes:
>
> The problem is that the V doesn't have an AL output.
>
>
> Neither does the Orion.
>
> And you'll need a RF sensing switch to put the amp into transmit mode.
>
> k4ia
> Craig "Buck"
> Fredericksburg, Virginia USA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|