In a message dated 10/29/06 10:35:07 PM Greenwich Standard Time, dbp@tds.net
writes:
> Hi-
> So as not to re-invent the wheel: Considering using my Argonaut V to drive
> my amp to 300 Watts or so. I had done same years ago with the first
> Argonauts.
> I haven't looked for a point to take the T/R signal from to drive a
> transistor switch- have you? (Manual is on its way)
>
There's another issue besides amp switching: the Argo V has no provision for
ALC control. That's probably not a problem for most amps, with only 20 W of
drive, but you didn't say what sort of amp you're using.
73,
Ray W2RS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|