I'm working on bring a Century 21 carcass back to life and I'm a little
puzzled by the VFO dial mechanism - I thought the VFO was in need of
rebuild, but it appears instead that the gears were not properly positioned,
preventing the VFO from moving normally. Unfortunately the Ten-Tec VFO
rebuild information I found doesn't elaborate on the proper assembly of the
VFO dial mechanism. If someone familiar with this would be able to assist by
e-mail, I'd be grateful for the help.
Very tks,
73 Dave WB0GAZ wb0gaz@hotmaill.com
_________________________________________________________________
http://homepage.msn.com/zune?icid=hmetagline
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|