That's too bad....not you and your software, Carl, but the fact that the
band data is not available on the back of the radio.
Forgive me if I sound a but retro here, but.....
I think I will stay with my Omni VI's where my radios control the antenna
switching and bandpass filters.....without having to have the computer
turned on.
73,
Dale, kg5u
>
> There are no band outputs on the back of the Omni VII.
> Computer control is the answer. My N4PY software will have
> full function for this.
>
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, North Carolina 28635
>
> ----- Original Message -----
> From: <k7gt@charter.net>
> To: <tentec@contesting.com>
> Sent: Thursday, March 08, 2007 11:22 AM
> Subject: [TenTec] OmniVII band output info??
>
>
> > Hi gang,
> >
> > A question for those with OmniVIIs. I reviewed briefly the OmniVII
> > manual
> that is
> > on-line and couldn't locate an output for band information. Both the
> OmniVI and Orion
> > have that info available on the back panel (so did the
> Corsair I and
> > some
> earlier rigs).
> > Has this very useful feature been dropped or does one have to go
> > through
> computer
> > control to get that info?
> >
> > Otherwise it looks like the VII may be in my future.
> >
> > Allan K7GT
> >
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|