| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Stripping working Rigs for parts |
| From: | <k8vf_mark@centurytel.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 15 Mar 2007 18:37:01 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Yes, PLEASE, this listing had a copy of Ten Tec work order showing all in good order. The rig was sent to Ten Tec to verify all was well, THEN stripped down to the knobs......... I just had to ask, it bothered me a lot. I guess I saw no need for it, that was all. mark _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Pimping parts, Grant Youngman |
|---|---|
| Next by Date: | Re: [TenTec] Pimping parts, John Cox |
| Previous by Thread: | [TenTec] Primarilly an introduction, David Chernenkoff |
| Next by Thread: | [TenTec] Stripping working Rigs for parts, Paul |
| Indexes: | [Date] [Thread] [Top] [All Lists] |