My N4PY Orion Software has a procedure to do this.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Kim Elmore" <cw_de_n5op@sbcglobal.net>
To: "Tentec Contesting List" <tentec@contesting.com>
Sent: Monday, February 18, 2008 8:32 AM
Subject: [TenTec] Frequency Misalignment Between VFO A and VFO B
> For some time, I've noticed what seemed to be a very slight
> frequency misalignment between VFO A and VFO B when in the binaural
> mode (A in one ear and B in the other).
>
> On my O II it's noticeable even in the noise as what sounds like a
> beat note in stereo phasing when both VFOs are tuned to the same
> frequency. Last night, I chased this down and found that VFO B is
> about 6 Hz lower in frequency that VFO A. This isn't a terribly big
> deal, but is there a way to align the two, or are the master
> oscillators different so that the two drift around slightly as a
> matter of course?
>
> Kim Elmore, N5OP
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|