W3GQJ wrote:
> I have heard that it works when the front panel RIT/XIT won't
work. You still need to turn on the RIT/XIT from the front panel,
but then you can change it with the POD.
I had the 302R Pod and can confirm this,
which caused me to feel it was not firmware but the
encoder itself. See my post from May 2004 below:
http://dayton.contesting.com/archives//html/TenTec/2004-05/msg00620.html
"Actually my RIT/XIT knob is acting up now so I can't check it.
It works intermittently even though the 302R works perfectly, so
there may be a hardware problem with its encoder."
You may be on the right track with
the cable but I wonder why that would affectRIT only and not other
functions on that cable?
Good luck with your detective work!
73, Bill W4ZV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|