Thank you Paul, that did the trick I will reload the memories and get back to
normal operations. I have the Orion I running 160, 80 and 40 with 40 on
antenna B with a separate amp. The Orion II is used on 60 and the high bands,
beam and solid state amp SG-500 with 60 on antenna 2 with no amp.
Getting a little "gun shy", four hurricanes in the last four(4) years lots of
antennas and other gear lost. Thanks to the reflector also
73,s W5SJL Amos
----- Original Message -----
From: Paul Clinton<mailto:service@tentec.com>
To: Amos Favorite<mailto:w5sjl@msn.com>
Sent: Monday, December 29, 2008 1:14 PM
Subject: Re: [TenTec] ORION II Problem
Dear Amos:
Do a master reset and clear user memories.
73,
Paul R. Clinton
WD4EBR
Service Manager
----- Original Message -----
From: Amos Favorite<mailto:w5sjl@msn.com>
To: service@tentec.com<mailto:service@tentec.com>
Sent: Monday, December 29, 2008 11:27 AM
Subject: FW: [TenTec] ORION II Problem
Hello guys, have I got something set wrong, got all the controls set normal
on antenna 1 also tried antenna 2 where I run sixty(60) meters all the same
symptoms below.
> From: w5sjl@msn.com<mailto:w5sjl@msn.com>
> To: tentec@contesting.com<mailto:tentec@contesting.com>
> Date: Mon, 29 Dec 2008 15:38:33 +0000
> Subject: [TenTec] ORION II Problem
>
>
> Been off the air for a few months, ORION II S/N 06C10135, has the
following symptoms.
>
>
> No RX without the preamp turned on Main receiver, all bands all modes
> No power output, SWR 1.0: 1 all bands all antennas
> Did not do any resets, diagnostics???
> Verified all menu Items back to the recorded settings and compared to the
ORION I that is still good
>
> Any suggestiosn to avoid the big box hassel?
>
>
> 73's DId not do a reset
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|