If I'm not mistaken, the baud rate of the computer must match the baud rate set
in the device. Is there a default baud rate? Is there a means to change the
baud rate in the TenTec -- be it via software or hardware? (DIP switches, etc?)
73 de Phil - N8PS
-----------
Quoting Ed <w3nr@comcast.net>:
> CSM(r) Gary Huber wrote:
> > Note; if you choose to use only DB-9 pins 2,3, and 5 for signal, you must
> > use 9600 baud and below speeds with software flow (XON - XOFF) flow
> control.
> >
>
>
> Thats strange, I only use 2-3-5 and 19200 and all works perfectly. I
> must have missed the above somewhere.
>
> Ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|