| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair II / 263 VFO Question |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 08 Mar 2009 16:03:03 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Jerry's correct - you need the Pin 2 to Pin 6 jumper to enable the internal Corsair PTO. Steve G3TXQ Dr. Gerald N. Johnson wrote: > > Needs a jumper on the Accessory socket. Pin 2 to 6 according my my > Corsair II manual. Lower left corner of the block diagram page. > > 73, Jerry, K0CQ > > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Corsair II / 263 VFO Question, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] Corsair II / 263 VFO Question, Gary Smith |
| Previous by Thread: | Re: [TenTec] Corsair II / 263 VFO Question, Dr. Gerald N. Johnson |
| Next by Thread: | Re: [TenTec] Corsair II / 263 VFO Question, Gary Smith |
| Indexes: | [Date] [Thread] [Top] [All Lists] |