My Omni VI has a small bit of carrier showing on LSB that is not present on
USB. Also there is a full output switching transient when I key the mike in
LSB; it is less than half on USB.
Can this alignment/null be performed with a minimum of test equipment? I
don't have a service monitor capable of 1 Hz readout. I seem to remember some
discussion on the switching transient a few years ago, so I will try to check
the archives.
73, John
**************New Low Prices on Dell Laptops – Starting at $399
(http://pr.atwola.com/promoclk/100126575x1220631247x1201390185/aol?redir=http:%2F%2Fad.doubl
eclick.net%2Fclk%3B213540506%3B35046329%3Bx)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|