You might want to check your tuning rate. It's in Menu 3 and comes up as SPD.
Dave
WA3MKB
----- Original Message -----
From: "Ron Zond" <k3miy@csonline.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, April 21, 2009 9:24:31 PM GMT -05:00 US/Canada Eastern
Subject: Re: [TenTec] Omni VI, Opt 3: Strange Tuning Behavior
John
it may be a PLL problem.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of John Unger
Sent: Tuesday, April 21, 2009 7:41 PM
To: tentec@contesting.com
Subject: [TenTec] Omni VI, Opt 3: Strange Tuning Behavior
My Omni VI has developed a strange tuning behavior. When I tune through a
CW signal, instead of the tone continuously varying as I tune through it,
the tone changes in discreet steps every 150 or 200 Hz (the step width
seems to depend on the band, but is always in multiples of 5 Hz).
Has any one experienced this type of behavior or does anyone have any ideas
about what is going on?
tnx es 73 - John, W4AU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|