Thank you very much.
How far are you from Hendersonville? My granddad used to live there. His call
was W1HVA
73,
Steve
-----Original Message-----
From: N4PY2 <n4py2@earthlink.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Tue, Dec 29, 2009 8:03 pm
Subject: Re: [TenTec] Orion firmware
Yes, you can use the same install program for the Orion and Oiron II. But
ou must use a different RUF file for each one.
Carl Moreschi N4PY
21 Little Bell Drive
ays, NC 28635
ww.n4py.com
---- Original Message -----
rom: <w1dxh@aol.com>
o: <tentec@contesting.com>
ent: Tuesday, December 29, 2009 8:01 PM
ubject: [TenTec] Orion firmware
when updating firmware I see you need both ruf file as well as an (install
file) sorry for lack of better term. this is my first attempt at a firm
ware update and install and just want to make sure I am doing it correct.
Are both the Orion and Orion 2 install files te same? I have looked at
TenTec site and can't see any specifics to the Orion verses the Orion 2
thanks in advance.
73,
Steve W1DXH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
enTec mailing list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|