Air movement is the problem.... the heat is blowing away. Use a box to
shield the work from the wind. If the flame of a match or candle isn't
going straight up, you'll have a hard time soldering...
--------------------------------------------------
From: "John Molenda" <cdistflatfoot@gmail.com>
Sent: Monday, April 05, 2010 4:52 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] help in soldering pl259 outside
> Well it's that time again that is Antenna time . I was out side
> yesterday
> in 60 degree temp and had a very diffucult time soldering on some
> connectors . Does anyone on the reflector have any tricks for soldering
> outside both my irons were not hot enough . Does anyone make a special
> slodering tool for such a job ? thanks John kb2huk
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|