| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] help in soldering pl259 outside |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 06 Apr 2010 17:17:33 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Yes. I use a "burnishing tool" to remove the oxide off any such connector, regardless of metal type, which I purchased from RS when I was a kid. =================== JHR ============================ On 4/6/2010 4:35 PM, Dave Haupt wrote: Get a small enough steel-bristle brush ====================================================== _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Corsair frequencies wrong, Richards |
|---|---|
| Next by Date: | Re: [TenTec] help in soldering pl259 outside, Bill Harris |
| Previous by Thread: | Re: [TenTec] help in soldering pl259 outside, Dave Haupt |
| Next by Thread: | Re: [TenTec] help in soldering pl259 outside, Bill Harris |
| Indexes: | [Date] [Thread] [Top] [All Lists] |